May 22, 2020   |   by admin

This Quick Installation Guide contains introduction of the motherboard and step-bystep installation guide. It starts up and runs windows 10 with no problem. All Auction Buy it now. Make sure the red-striped side of the cable is plugged into Pin1 side of the connector. We are not responsible for possible damage caused by overclocking. Place the heatsink onto the socket.

Uploader: Gogrel
Date Added: 6 May 2012
File Size: 48.47 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 86998
Price: Free* [*Free Regsitration Required]

Then, the drivers compatible to your system can be auto-detected and g31m-z on fsh support CD driver page. Skip to main content. Please refer to below illustrations tor the pin definition of onboard headers. Otherwise, the CPU will be seriously damaged. Make sure the red-striped side of the cable is plugged into Pin1 side of the connector. Please do not ask for specs as I do not know and I do not have time to go through it and find out.

The above user interface picture is a sample for reference. Before you resume the system, please check if the CPU fan on the motherboard functions properly and unplug the power cord, then plug it back again. Item location see all.



The data in CMOS includes system setup information such as system password, date, time, and system setup parameters.

Just launch this tool and save the new BIOS file to your USB flash drive, floppy disk or hard drive, then you can update your BIOS only in a few clicks without preparing an additional floppy diskette or other complicated flash utility. Buying format see all. No part of this installation guide may be reproduced, transcribed, transmitted, or translated in any language, in any f o r m or by any m e a n sexcept duplication of d o c u m e n tation by the purchaser for backup purpose, without written consent of A S R o c k Inc.

Rotate the load plate onto the IHS. Please visit our website for the operation procedures of Intelligent Energy Saver. While CPU overheat is detected, the system will automatically shutdown.

Unlock a DIMM slot by pressing the retaining clips outward. Please refer to the warning on page 8 ffsb the possible overclocking risk before you apply Untied Overclocking Technology. Then conned to the power cable to the power powersupply connector of the power supply.

VillMan Computers

Everything is fully tested unless otherwise stated. Please refer to page 16 for proper jumper settings. It is recommended to use the cap tab to handle and avoid kicking off the PnP cap.


Keep the screws for later use. Secure load lever with load plate tab under retention tab of load lever. There seems to be a problem completing the request at present. Locate Pin1 and the two orientation key aaudio.

Supports D-Sub with max. This cap must be placed if returning the motherboard for after service. In case any modifications of this manual occur, the updated version will be available on ASRock website without further notice. See the attached pics the item you get is the one in the pic. Do N O T place jumper caps over audlo headers and connectors. After restarting your computer, you will find “Mixer” tool on your system.

Also remember to use a grounded wrist strap or touch a safety grounded object before you handle components.

A S R o c k assumes no responsibility for any errors or omissions that may appear in this guide. More refinements More refinements